Top » Shop » 1-Wire Interfaces » LinkUSB-T My Cart | Checkout

Catalog

Back
LinkUSB-T 34.90 €
Advanced 1-Wire USB Adapter with Screw Terminal
The LinkUSB-T is an advanced, intelligent USB 2.0 full speed interface for use with Dallas Semiconductor 1-Wire and iButton components. It uses superior digital and analog methods to accomplish more-reliable operation on a wide variety of network topologies. It also offers many functions that simplify network communications and some diagnostic tools as well.

This version of the LinkUSB features a micro USB port and uses a micro USB cable, which eliminates the strain point between the LinkUSB's electronics and the USB connector. In addition, this version of the LinkUSB also features a 3-pin screw terminal in place of the RJ45 port. The 3-pin screw terminal allows the user to use a wide range of wire sizes and gives them the ability to hardwire in the LinkUSB.

The LinkUSB-T has been designed to operate reliably on long and short 1-Wire busses. It has a special analog interface design that uses matched impedances and slew rate controls, as well as smart cable pre-charge. In addition, the firmware (programming) is adaptive and makes adjustments for a variety of network parameters automatically.

The LinkUSB-T is based on The Link, which was designed in cooperation with Dallas Semiconductor Corp., Dallas, Texas, manufacturer of 1-Wire and iButton devices and various accessories. Some terms used in this document may be trademarks of Dallas Semiconductor Corporation, and are used with their permission. Application note 244 from the Maxim-Dallas web site describes the improvements implemented by the LinkUSB-T in greater detail.

USB to Serial Bridge
The LinkUSB-T is based on the proven iButtonLink Link45 product, with an FTDI FT232R USB UART chip bridging the USB to the internal microprocessor's serial port. The FT232R is USB 2.0 Full Speed compatible. Drivers should already be present in recent Windows versions. The latest driver versions for Windows, Linux and Macintosh may be downloaded from http://www.ftdichip.com/.

The FTDI driver creates a virtual COM port on the host computer to communicate with the LinkUSB-T. If you change the virtual COM port baud rate it changes the baud rate in the FT232R chip that connects to the LinkUSB-T microprocessor. This will make the LinkUSB-T appear unresponsive until the baud rate is returned to its previous setting. The proper sequence to enable higher baud rates is to first change the LinkUSB-T baud rate first the ASCII '^', '`', or ',' commands, then change the virtual COM port speed.


Examples of Accessories


LinkUSB-T
LinkUSB-T LinkUSB-T 
Product No.: 72791
EUR 34.90
incl. 16% VAT
plus Shipping costs

 
» Leadtime
In Stock
 
» Documents
 
» Downloads
 
Back  
You Might Also Like
USB cable A/micro-B 0.15m
USB cable A/micro-B 0.15m
USB cable A/micro-B 1.0m
USB cable A/micro-B 1.0m
DS18B20+
DS18B20+
DS2401+
DS2401+

My Cart

0 items

Manufacturer

Logo iButtonLink
iButtonLink

Information

New

Our partners

Partnerships