fuchs-shop.com: DS2482S-100

Top » Shop » Components » DS2482S-100

Shopping Cart | Checkout

Catalog

1-Wire Products

iButton Products

Bus-Installation

Other Products

Back

DS2482S-100 1.60 €

Single-Channel 1-Wire Master

The DS2482S-100 is an I2C-to-1-Wire® bridge device that interfaces directly to standard (100kHz max) or fast (400kHz max) I2C masters to perform bidirectional protocol conversion between the I2C master and any downstream 1-Wire slave devices. Relative to any attached 1-Wire slave device, the DS2482S-100 is a 1-Wire master. Internal, factory-trimmed timers relieve the system host processor from generating time-critical 1-Wire waveforms, supporting both standard and overdrive 1-Wire communication speeds.

To optimize 1-Wire waveform generation, the DS2482S-100 performs slew-rate control on rising and falling 1-Wire edges and provides additional programmable features to match drive characteristics to the 1-Wire slave environment.

Programmable, strong pullup features support 1-Wire power delivery to 1-Wire devices such as EEPROMs and sensors. The DS2482S-100 combines these features with an output to control an external MOSFET for enhanced strong pullup application. The I2C slave address assignment is controlled by two binary address inputs, resolving potential conflicts with other I2C slave devices in the system.

Features

I2C Host Interface Supports 100kHz and 400kHz I2C Communication Speeds
1-Wire Master IO with Selectable Active or Passive 1-Wire Pullup
Provides Reset/Presence, 8-Bit, Single-Bit, and 3-Bit 1-Wire IO Sequences
Standard and Overdrive 1-Wire Communication Speeds
Slew-Controlled 1-Wire Edges
Selectable 1-Wire Slave Presence-Pulse Falling Edge Masking to Control Fast Edges on the 1-Wire Line
Strong 1-Wire Pullup Provided by an Internal Low-Impedance Signal Path
PCTLZ Output to Optionally Control an External MOSFET for Stronger Pullup Requirements
Two Address Inputs for I2C Address Assignment
Operating Range: 2.9V to 5.5V, -40°C to +85°C