fuchs-shop.com: DS2450S

Top » Shop » Components » DS2450S

Shopping Cart | Checkout

Catalog

1-Wire Products

iButton Products

Bus-Installation

Other Products

Back

DS2450S 4.80 €

1-Wire Quad A/D Converter

The DS2450 1-Wire Quad A/D Converter is based on a successive-approximation analog to digital converter with a four to one analog multiplexer. Each input channel has its own register set to store the input voltage range, resolution, and alarm threshold values as well as flags to enable participation of the device in the conditional search if the input voltage leaves the specified range. Two alarm flags for each channel indicate if the voltage measured was too high or too low without requiring the bus master to do the comparison. Each A/D conversion is initiated by the bus master. A channel not used as analog input can serve as a digital open-drain output. After disabling the input the bus master can directly switch on or off the open-drain transistor at the selected channel. All device settings are stored in SRAM and kept
non-volatile while the device gets power either through the 1-Wire bus or through its Vcc pin.

After powering up, a power-on reset flag signals the bus master the need to restore the device settings before the regular operation can resume. All device registers and conversion read-out registers are organized as three 8-byte memory pages similar to the Status Memory of a DS2505/6 device. An on-chip CRC16 generator protects the communication against transmission errors when reading through the end of a memory page as well as when writing individual bytes.

Features

Four high-impedance inputs to measure analog voltages over the 1-Wire® bus
User programmable input range (2.56V, 5.12V), resolution (1 to 16 bits) and alarm thresholds
5V, single supply operation
Very low power: 2.5 mW active
Built-in multidrop controller allows multiple DS2450's to be identified and operated on a common 1-Wire bus
Responds to Conditional Search if the analog voltage crosses the alarm thresholds
Channels not used as analog input can serve as open drain digital outputs for closed-loop control
Directly connects to a single port pin of a microprocessor and communicates at up to 16.3k bits per second
Overdrive mode boosts communication speed to 142k bits per second
On-chip 16-bit CRC-generator for safeguarding data transfers
Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number 8-bit CRC tester) assures absolute traceability because no two parts are alike
8-bit family code specifies device communication requirements to bus master
Operating temperature range from -40°C to +85°C
Compact, low cost 8-pin SOIC surface mount package